• Contact Us

    +985632255201-3

  • Contact Hours

    8 am to 5 pm

Light Steel Buildings

Style Buildings

Style buildings using Wood stud (wood) or Metal stud (metal) has been implemented for many years in advanced countries are introduced below.

Style buildings in America is very common. Was implemented in old wood so typical of joiner of 5 to 10 cm (Wood Stud) and both sides of the timber frame building built in a way they joinery.

With advances in building technology, in joinery of an inch gypsum board or precast concrete used and the hole in Stud wires, water pipes and so on through the day and sharing them with sound isolation and compacting the heat exchange between the two stud them.

As well as plaster or concrete walls, buildings in front of the fire resistant. Made with Wood Stud buildings without using columns and steel beams can be designed to Chhartbqh. Today in America many of the buildings are made to the Trtbyb.

Bagrat wood and wood against termites vulnerability rather than timber (Wood Stud) thick on average less than 2 mm of studs used (metal stud). It runs just like wood instead of nails and screws used car due to the elasticity of the stud buildings (metal stud) are highly resistant against earthquakes as well as the type of buildings, without using a bow and metal column be Tahft floors.

It is noteworthy that in high-rise buildings and Tilt-Up Use the (metal stud) for non-load-bearing interior walls and Dyvrahay interior walls are very common. So use it a perfect solution for residential and light commercial buildings.

 

The benefits of light steel structures

  • flexibility
  • Strong sections
  • Good audio performance
  • Fireproof
  • High speed performance
  • High and uniform quality of the final product
  • Of global energy consumption standards
  • The lightness and the force exerted on the structure earthquake
  • Workshop requires little space and safety in the workplace
 

Disadvantages of light steel structures

  • Openings are limited in size
  • And expert manpower needs
  • Floors can be manufactured with this system is limited
  • Supply of galvanized metal parts produced at the plant is relatively high cost